HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 163)

HEIDENHAIN TNC 320 163
6.4 P
a
th Cont
ours—Car
te
sian Coor
dinat
e
s
6.4 Path Contours—Cartesian
Coordinates
Overview of path functions
Programming path functions
You can program path functions conveniently by using the gray path
function keys. In further dialogs, you are prompted by the TNC to
make the required entries.
Function Path function key Tool movement Required input Page
Line L Straight line Coordinates of the end
points of the straight line Page 164
Chamfer CHF
Chamfer between two
straight lines Chamfer side length Page 165
Circle Center CC None Coordinates of the circle
center or pole Page 167
Circle C
Circular arc around a circle
center CC to an arc end point Coordinates of the arc end
point, direction of rotation Page 168
Circular arc CR
Circular arc with a certain
radius Coordinates of the arc end
point, arc radius, direction of
rotation Page 169
Circular arc CT
Circular arc with tangential
connection to the preceding
and subsequent contour
elements Coordinates of the arc end
point Page 171
Corner Rounding RND
Circular arc with tangential
connection to the preceding
and subsequent contour
elements Rounding radius R Page 166
If you enter DIN/ISO functions via a connected USB
keyboard, make sure that capitalization is active.