HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 141)

HEIDENHAIN TNC 320 141
5.2 T
ool D
a
ta
Pocket table for tool changer
For automatic tool changing you need the pocket table TOOL_P.TCH.
The TNC can manage several pocket tables with any file names. To
activate a specific pocket table for program run you must select it in
the file management of a Program Run mode of operation (status M).
Editing a pocket table in a Program Run operating mode
U Press the TOOL TABLE soft key to select the tool
table
U Press the POCKET TABLE soft key to select the
pocket table
U Set the EDIT soft key to ON. On your machine this
might not be necessary or even possible. Refer to
your machine manual
The machine tool builder adapts the functional range of
the pocket table to the requirements of your machine. The
machine tool manual provides further information.