HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles - Manual (Page 9)

HEIDENHAIN TNC 320 9
1.1 General Information on Touch Probe Cycles ..... 16
Method of function ..... 16
Consider a basic rotation in the Manual Operation mode ..... 16
Touch probe cycles in the Manual and Electronic Handwheel modes ..... 16
Touch probe cycles for automatic operation ..... 17
1.2 Before You Start Working with Touch Probe Cycles ..... 19
Maximum traverse to touch point: DIST in touch probe table ..... 19
Set-up clearance to touch point: SET_UP in touch probe table ..... 19
Orient the infrared touch probe to the programmed probe direction: TRACK in touch probe table ..... 19
Touch trigger probe, probing feed rate: F in touch probe table ..... 20
Touch trigger probe, rapid traverse for positioning: FMAX ..... 20
Touch trigger probe, rapid traverse for positioning: F_PREPOS in touch probe table ..... 20
Multiple measurements ..... 20
Confidence range for multiple measurement ..... 20
Running touch probe cycles ..... 21
1.3 Touch probe table ..... 22
General ..... 22
Editing touch probe tables ..... 22
Touch probe data ..... 23
1 Working with Touch Probe Cycles ..... 15