HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles - Manual (Page 13)

HEIDENHAIN TNC 320 13
4.1 Tool Measurement with the TT Tool Touch Probe ..... 148
Overview ..... 148
Setting the machine parameters ..... 148
Entries in the tool table TOOL.T ..... 150
4.2 Available Cycles ..... 152
Overview ..... 152
Differences between Cycles 31 to 33 and Cycles 481 to 483 ..... 152
Calibrating the TT (touch probe cycle 30 or 480, DIN/ISO: G480) ..... 153
Measuring the tool length (touch probe cycle 31 or 481, DIN/ISO: G481) ..... 154
Measuring the tool radius (touch probe cycle 32 or 482, ISO: G482) ..... 157
Measuring the tool radius (touch probe cycle 33 or 483, ISO: G483) ..... 159
4 Touch Probe Cycles for Automatic Tool Measurement ..... 147