HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles - Manual (Page 22)

22
1
.3 T
ouc
h pr
obe table
1.3 Touch probe table
General
Various data is stored in the touch probe table that defines behavior
with the probe process. If you run several touch probes on your
machine tool, you can save separate data for each touch probe.
Editing touch probe tables
To edit the touch probe table, proceed as follows:
8 Select the Manual operating mode
8 To select the touch probe functions, press the PROBE
FUNCTION soft key. The TNC displays additional soft
keys — see table above.
8 Select the touch probe table: Press the TOUCH
PROBE TABLE soft key.
8 Set the EDIT soft key to ON
8 Using the arrow keys, select the desired setting
8 Perform desired changes
8 Exit the touch probe table: Press the END soft key