Corner as datum, 4 set ting the d a tu m with a 3-d t o uc h pr obe – HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles User Manual
Page 35
HEIDENHAIN TNC 320
35
2.4 Set
ting the D
a
tu
m with a 3-D T
o
uc
h Pr
obe
Corner as datum
8
Select the probe function by pressing the PROBING P
soft key.
8
Position the touch probe near the first touch point on
the same side of the workpiece.
8
Select the probe direction by soft key.
8
To probe the workpiece, press the machine START
button.
8
Position the touch probe near the second touch point
on the same side.
8
To probe the workpiece, press the machine START
button.
8
Position the touch probe near the first touch point on
the second side of the workpiece.
8
Select the probe direction by soft key.
8
To probe the workpiece, press the machine START
button.
8
Position the touch probe near the second touch point
on the same side.
8
To probe the workpiece, press the machine START
button.
8
Datum:
Enter both coordinates of the datum in the
menu window, confirm with the SET DATUM soft
key, or write the values to a table (see “Writing the
measured values from touch probe cycles in datum
tables,” page 27, or see “Writing the measured
values from touch probe cycles in the preset table,”
page 28).
8
To terminate the probe function, press the END key.
P
X=?
Y=?
X
Y
P
X
Y