HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles - Manual (Page 150)

150
4.1 T
o
ol Measur
ement with the T
T
T
ool T
o
uc
h Pr
obe
Entries in the tool table TOOL.T
Abbr. Inputs Dialog
CUT Number of teeth (20 teeth maximum) Number of teeth?
LTOL Permissible deviation from tool length L for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L). Input
range: 0 to 0.9999 mm Wear tolerance: length?
RTOL Permissible deviation from tool radius R for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L). Input
range: 0 to 0.9999 mm Wear tolerance: radius?
DIRECT. Cutting direction of the tool for measuring the tool during rotation Cutting direction (M3 = –)?
R-OFFS For tool length measurement: Tool offset between stylus center
and tool center. Default setting: No value entered (offset = tool
radius) Tool offset: radius?
L-OFFS Tool radius measurement: tool offset in addition to
offsetToolAxis
between upper surface of stylus and lower
surface of tool. Default: 0
Tool offset: length?
LBREAK Permissible deviation from tool length L for breakage detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Breakage tolerance: length?
RBREAK Permissible deviation from tool radius R for breakage detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Breakage tolerance: radius?