HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles - Manual (Page 102)

102
3.2 Pr
eset
ting aut
o
matically
2 TCH PROBE 413 DATUM OUTSIDE CIRCLE
Q321=+25 ;CENTER 1ST AXIS Center of circle: X coordinate
Q322=+25 ;CENTER 2ND AXIS Center of circle: Y coordinate
Q262=30 ;NOMINAL DIAMETER Diameter of circle
Q325=+90 ;STARTING ANGLE Polar coordinate angle for 1st touch point
Q247=+45 ;STEPPING ANGLE Stepping angle for calculating the starting points 2 to 4
Q261=-5 ;MEASURING HEIGHT Coordinate in the touch probe axis in which the measurement is
made
Q320=2 ;SET-UP CLEARANCE Safety clearance in addition to SET_UP column
Q260=+10 ;CLEARANCE HEIGHT Height in the touch probe axis at which the probe can traverse
without collision
Q301=0 ;MOVE TO CLEARANCE Do not move to clearance height between measuring points
Q305=0 ;NO. IN TABLE Set display
Q331=+0 ;DATUM Set the display in X to 0
Q332=+10 ;DATUM Set the display in Y to 10
Q303=+0 ;MEAS. VALUE TRANSFER Without function, since display is to be set
Q381=1 ;PROBE IN TS AXIS Also set datum in the touch probe axis
Q382=+25 ;1ST CO. FOR TS AXIS X coordinate of touch point
Q383=+25 ;2ND CO. FOR TS AXIS Y coordinate of touch point
Q384=+25 ;3RD CO. FOR TS AXIS Z coordinate of touch point
Q333=+0 ;DATUM Set the display in Z to 0
3 CALL PGM 1860 Part program call
4 END PGM CYC413 MM