Grass Valley NV8500 Series v.3.5 - Manual (Page 78)

62
Inputs and Outputs
Time Code
Making Video Reference Connections
1 Locate the video reference connections on the rear of the router, as shown in Figure 2-23.
Video reference connections are labeled VIDEO REF 1 and VIDEO REF 2.
Fig. 2-23: Video Reference Connections (Rear View)
2 Connect VIDEO REF 1, using a 75
W BNC cable on one or the other connector, to a video ref-
erence signal. The signals can be:
PAL
NTSC
Tri-level sync
3 Either use the other connector to continue the reference signal to another device or termi-
nate the reference signal by installing a 75
W BNC terminator on this connector.
4 Connect to VIDEO REF 2 as described in steps 2 and 3.
Time Code
There is one connection for time code signals (labeled TIME CODE). Time code signals are not
supported at this time.
Video Reference Con-
nectors