Grass Valley NV8500 Series v.3.5 - Manual (Page 111)

95
NV8500 Series
User’s Guide
Making NV8280 Monitor Connections
1 Face the rear of the router. The output monitor backplane and the input monitor backplane
are located at the left end of the output bay. (See Figure 1-9 on page 12.) The monitor back-
planes are marked as output and input. Each monitor backplane has two input connectors
and two output connectors, labeled IN 1, IN 2, OUT 1, and OUT 2.
2 Ignore the input connectors, IN 1 and IN 2.
3 Connect OUT 1 and OUT 2 on the output monitor backplane to the section of your monitor-
ing equipment that monitors output.
4 Connect OUT 1 and OUT 2 on the input monitor backplane to the section of your monitoring
equipment that monitors input.
Making NV8576 Monitor Connections
1 Face the rear of the router. The 4 monitor backplane slots are located at the left end of the
upper output bay and at the right end of the lower output bay. (See Figure 1-11 on page 15.)
The monitor backplanes are marked as output and input. Each monitor backplane has two
input connectors and two output connectors, labeled IN 1, IN 2, OUT 1, and OUT 2.
2 Connect OUT 1 and OUT 2 of the input monitor backplane in the lower bay to IN 1 and IN 2,
respectively, of the input monitor backplane in the upper bay.
3 Connect OUT 1 and OUT 2 of the output monitor backplane in the lower bay to IN 1 and IN 2,
respectively, of the output monitor backplane in the upper bay.
4 Connect OUT 1 and OUT 2 on the input monitor backplane in the upper bay to the section of
your monitoring equipment that monitors output.
5 Connect OUT 1 and OUT 2 on the output monitor backplane in the upper bay to the section
of your monitoring equipment that monitors input.
Figure shows the monitor connections for the NV8576, for output monitoring:
Fig. 5-5: Monitor connections for NV8576 (Rear View)
Inputs
Outputs
Inputs
Outputs
To
equipment
1
2