Grass Valley NV8500 Series v.3.5 User Manual
Page 36
20
Introduction
Rack Mount
6 Reinstall control cards, crosspoint cards, I/O cards, I/O backplanes, monitor cards, and moni-
tor backplanes. Be sure to install them in the correct location. The router was configured at
the factory with the cards in a specific location. If you install I/O cards in a different location,
the router will have to be reconfigured before it can run properly.
7 If you are using NV8300 power supplies, perform the following steps:
a If the NV8300 was shipped with the PS8300 power supply modules in the frame, remove
the modules.
b Lift the power supply frame into position and attach the power supply frame to the front
of the rack with the appropriate screws. Place screws in all frame mounting screw holes.
c Repeat steps a and b for additional power supply frames.
8 Re-mount the front door.
9 Wait until you have completed all installation tasks before you reinstall PS8300 power supply
modules, powering up the router. (See
CAUTION
Do not re-insert the PS8300 power supply modules until after you have made all
power connections. For more information, see