Grass Valley NV8500 Series v.3.5 - Manual (Page 152)

136
Configuration
NV9000-SE Utilities
NV9000-SE Utilities
Use NV9000-SE Utilities to configure the inputs and outputs (of the NV9000 router control
system) that are connected to, and used by, the NV8500 family routers.
iControl-Solo
iContol-Solo is used to configure the various frame sync functions of frame sync input cards of
the NV8500 Series routers.
These are the functions available, in the frame sync card, for each video channel:
1 You can configure 16 ×16 audio shuffles.
2 You can change gain and offset in either the YCrCB or RGB space. You can also change the
hue in the YCrCb space.
3 You can set audio gain and inversion (and muting) for each audio channel.
4 You can set the video delay (up to 3+ frames).
5 You can adjust audio delay (up to 2 sec).
6 Each channel is “Dolby E aware.” This means that the card performs adds and drops during
the guard band. It does not guarantee that the header packet is located in the correct line.
The video channels of the frame sync card are tied to the router frame’s REF 1 and ignore REF 2.
Browser Application
Refer to Chapter 10, Frame Sync Cards , on page 137 for more information about the browser
application.