Configuration in icontrol-solo, Initial window – Grass Valley NV8500 Series v.3.5 User Manual
Page 156
140
Frame Sync Cards
Configuration in iControl-Solo
Please refer to the NV8500 port enumeration drawings available from Grass Valley for complete
detail.
Configuration in iControl-Solo
This is a brief introduction to iControl-Solo as it applies to the configuration of NV8500 frame
sync input cards. Please refer to the iControl-Solo User’s Guide and to the FRS-1801 User’s Guide for
complete detail.
During configuration, the frame sync card behave as if it were an FRS-1801 Densité card.
There are two components to frame sync configuration:
•
Configuration of the card.
•
Configuration of the card’s video channels.
Initial Window
When you launch iControl-Solo, it first displays a splash panel and then presents an initial
window in which you can select devices to configure. The window might at first be devoid of
configurable devices, as show here: