Grass Valley Aurora Edit LD v.6.3 Installation - Manual (Page 30)

30 Aurora Edit Installation and Configuration Guide September 20, 2007
Chapter 3 Installing Optional Equipment
Installing the SDR or HDR Board Driver
Once you’ve installed the SDR or HDR board and connected the cables, you need to
install the board’s driver.
The driver for the SDR or HDR board is located on the Aurora Edit CD, in the Drivers
directory. You can use either the Found New Hardware Wizard or the Update Device
Driver Wizard to install the driver.
NOTE: The driver for the SDFX and HDFX boards is installed automatically when
you license Aurora Edit.
Connecting Audio and Video Cables to the Breakout Box
The following illustrations and table detail how to connect other video and audio
cables to your Aurora Edit system.
Balanced Audio IN
Channels 1 & 2
Balanced Audio OUT
Channels 1 & 2
AES/EBU Audio
IN & OUT
Serial
Digital
IN
Serial
Digital
OUT
External
Reference
(loop)
Composite/
Component
Video IN
Composite/
Component
Video OUT
RS-422
Machine
Control
Analog Audio
Output
Ch. 1 In Ch. 1 Out Ch. 2 In Ch. 2 Out Ch. 1/2 In Ch. 1/2 Out
BALANCED AUDIO
Ch. 1/2
AES/EBU
Audio
In
Out
In
Out
In
Out
In
Out 1 2
SDI Ref Loop Y/CVBS Pb/Y Pr/C Ch.1(L) Ch.2(R)
RS-422
SDR/HDR Breakout Box
SDFX/HDFX Breakout Box
IN 1 IN 2 OUT 2 OUT 1 OUT 4 OUT 3 OUT 6 OUT 5
ANALOG AUDIO
AUDIO
PREVIEW
DIGITAL AUDIO
AES/EBU
OUT 1/2
IN 1/2
OUT 3/4 OUT 5/6
ANALOG
VIDEO
Y/CVBS OUT
Y/CVBS IN
Pb/Y OUT
Pb/Y IN
Pr/C OUT
Pr/C IN
CVBS OUT
SDI
OUT 1
IN
OUT 2 1394 75 OHM
REF IN
Balanced Audio IN
Channels 1 & 2
Balanced Audio OUT
Channels 1- 6
AES/EBU
Audio IN
External
Reference
(loop)
Composite/
Component
Video IN
Composite/
Component
Video OUT
Serial
Digital
IN
Serial
Digital
OUT
AES/EBU
Audio OUT