Remote panel network configuration – Grass Valley Acappella v.3.2.4 User Manual
Page 96
96
Acappella — Instruction Manual
Section 4 — Software and Configuration
Remote Panel Network Configuration
The Panel Network Configuration page is used to change the IP Address,
SubNet Mask, Gateway IP Address, and Ethernet Port for the panel.
Figure 48. Remote Panel Network Configuration Page
Setting IP Addresses with Web Page
CAUTION If there is more than one panel or frame in a system, duplicate IP addresses
may exist. To resolve duplicate IP Addresses see
.
The IP addresses of the device can be set directly from its web page by
entering the new numbers in the
Ethernet IP:
,
Subnet Mask:
and G
ateway IP:
fields.
You will need to check
Do reset
and
Save New Settings
before the change will
take effect.
NetConfig Device ID Setting:
These buttons report the current identity of the control panel. Leave this
setting on
Acappella
for use with an Acappella system.