Grass Valley Acappella v.3.2.4 - Manual (Page 48)

48 Acappella — Instruction Manual
Section 3 — Panel Operation
Press and release of an inactive Enable button causes the following actions:
• Activates the panel, and
• Active Enable button is illuminated at High Tally.
Other button activity on an inactive panel (not enabled):
• Source Tally (on active Destinations) is displayed normally,
• Active Destination can be changed (by press and release of another
Destination button) to view Source status on the new Destination,
• Levels can be changed to view Source status on any Level, and
• A Destination Gang preset can be created, but not Taken.
Protect Button
No change is allowed to the current Source on a protected Destination,
either by action on this panel, or by any remote device (via ethernet) action.
Any device can enable or disable the Destination protection. The
Protect
button is red and is found on the lower right of the panel. See Figure 1 .
Protect Button Action
Press and release of the inactive Protect button to activate a Protect causes
the following actions:
• Active Protect button is illuminated at High Tally,
• Activates Protect status on the active Destinations, and
• All Destinations in a Destination Gang are protected.
Press and release of the active Protect button causes the following actions:
• Inactive Protect button is illuminated at Off Tally,
• Deactivates Protect on the active Destinations, and
• All Destinations in a Destination Gang are removed from the Protected
state.