Grass Valley Acappella v.3.2.4 - Manual (Page 54)

54 Acappella — Instruction Manual
Section 4 — Software and Configuration
Default System IP Addresses
Acappella systems ship with default IP addresses shown in Table 1 .
These defaults will need to be changed, especially if your Acappella system
has multiple frames and/or multiple remote panels. See
Setting IP
Addresses on page 60 for specific instructions.
CAUTION Encore and Prelude control systems employ consecutive IP addresses for
redundant matrix controller operation. Even though Acappella frames do not
support matrix controller redundancy, if they reside on an Encore or Prelude
network, the next higher IP address must be reserved and cannot be assigned
to another device on the network. Serious system communications problems
can occur if this next higher Acappella frame IP address is used on an Encore
or Prelude network.
Software
Acappella ships with a software CD. Several applications on the CD enable
you to make adjustments to the Acappella configuration. After you have
added a PC to the Acappella network, you need to install the Acappella
software on the PC.
Software Installation
The Acappella Software CD will install the Acappella Matrix software,
Acappella Remote Panel software, NetConfig application (a Network Con-
figuration Tool), NetConfig Instruction Manual, and the Acappella Instruc-
tion Manual on a PC.
1. Insert Acappella Software CD, it will autostart. If the CD does not start
look for the Setup.exe file.
Table 1. Acappella System Default IP Addresses
Device IP Address Subnet Mask Gateway
Acappella Matrix Frame 192.168.0.40 255.255.255.0 192.168.0.1
Acappella Remote Panel 192.168.0.41 255.255.255.0 192.168.0.1
User Provided PC
(recommended setting) 192.168.0.1 255.255.255.0 192.168.0.1