Verifying the configuration – H3C Technologies H3C SecBlade LB Cards User Manual
Page 54
48
d.
Select Four for LB Layer.
e.
Click Add next to Virtual Service IP, enter the IP address of the virtual service 61.159.4.100,
and click Apply.
f.
Select the mask 32 (255.255.255.255) and protocol type TCP.
g.
Enter the port number 80.
h.
Select the forwarding mode NAT, real service group HTTPGroup, and the Enable Virtual
Service option.
i.
Click Apply.
Figure 37 Creating virtual service VS
Verifying the configuration
After the server runs properly for a period of time, you can display the statistics to verify the configuration
of load balancing.
1.
Select Load Balance > Server Load Balance > IPv4 from the navigation tree.
2.
Click the Statistics tab.
3.
Click the virtual service name link of virtual service VS.
You can see the statistics on the page.