H3C Technologies H3C SecBlade LB Cards - Manual (Page 40)

34
Step Remarks
4. Creating a real service group Required.
IMPORTANT:
The maximum number of real service groups,
real services, and virtual services depends on
the resource configuration of the virtual
device. For more information, see
System
Management Configuration Guide.
5. Creating a real service Required.
6. Creating a virtual service Required.
7. Displaying server load
balancing statistics
Optional.
8. Enabling slow-offline Optional.
Configuring public parameters
1. Select Load Balance > Public Setting from the navigation tree.
The public parameter configuration page appears.
Figure 23 Public parameter configuration
2. Set whether to enable the saving last hop information function.
Enabling this function makes sure responses can be returned on the original path. This function
must be enabled on level 2 LB products in firewall load balancing.
3. Click Apply.
Configuring a health monitoring method
Load balancing supports multiple health monitoring types. This section describes only the types
supported by IPv6 server load balancing.
• HTTP—Monitors the availability of an HTTP service through HTTP access.
• ICMP—Monitors the reachability of a server by sending ICMP messages.
To configure a health monitoring method:
1. Select Load Balance > Health Monitor from the navigation tree.
The heath monitoring page appears.