H3C Technologies H3C SecBlade LB Cards - Manual (Page 39)

33
Figure 22 Statistics
Configuring IPv6 server/firewall load balancing
IPv6 firewall load balancing and server load balancing are configured in the same way. This section
describes the configuration of server load balancing.
Configuration considerations
The configuration considerations of IPv6 server load balancing are similar to those of Layer 4 IPv4 server
load balancing except that the former does not support ACL. For more information, see " Server load
balancing configuration considerations ."
Recommended configuration procedure
Step Remarks
1. Saving of the last hop
information
Saving of the last hop information must be enabled on a level 2 LB
product in firewall load balancing. This task is optional in other cases.
For more information, see "
Configuring public parameters ."
2. Enabling unidirectional traffic
detection
Unidirectional traffic detection must be enabled on an LB product in DR
server load balancing. This task is optional in other cases.
To configure unidirectional traffic detection, navigate to Security >
Session Table > Configuration.
3. Configuring a health monitoring
method
Optional.