H3C Technologies H3C SecBlade LB Cards - Manual (Page 20)

14
Item Description
Username Username and password for logging in to the RADIUS
server in RADIUS health monitoring, case sensitive.
The default username is admin, and there is no password.
The parameters are
available only on the
page for setting RADIUS
health monitoring
parameters.
Password
Authentication
Server Shared Key
Shared key for RADIUS authentication packets in RADIUS
health monitoring.
The default authentication server shared key is
0123456789.
RADIUS Packet
Source IP
Source IP address of RADIUS packets in RADIUS health
monitoring.
By default, no source IP address is specified, and the IP
address of the interface that sends the RADIUS packets is
the source IP address of the RADIUS packets.
Protocol Transmission protocol used by SIP health monitoring.
The parameters are
available only on the
page for setting SIP health
monitoring parameters.
Allowed Status
Code
When the response message returned by the SIP server
falls into the allowed status code range, the SIP health
monitoring succeeds. Otherwise, the SIP health monitoring
fails.
• If you select Any, the SIP health monitoring succeeds no
matter what response message is returned by the SIP
server.
• If you select Status Code List, you must further specify
status codes.
Source Port
Source port that sends detection packets for SIP health
monitoring.
Version Version and read-only community name used in SNMP
health monitoring. Read-only community name takes effect
on SNMPv1 and SNMPv2c.
By default, the version is v1, v2c, and v3, and the
read-only community name is public.
The parameters are
available only on the
page for setting SNMP
health monitoring
parameters.
Read-only
Community Name
Client Certificate
Local certificate of an SSL client policy in SSL health
monitoring, used for an SSL server to perform
certificate-based authentication on the client.
To apply a certificate, select Security > Certificate
Management > Certificate.
IMPORTANT:
If you adopt SSL health monitoring, you must configure the
Client Certificate.
The parameters are
available only on the
page for setting SSL
health monitoring
parameters.