Configuring the basic network settings, Verifying the network configuration – H3C Technologies H3C S7500E Series Switches User Manual
Page 63

52
Configuring the basic network settings
•
Configure IP addresses.
# Create VLAN-interface 1.
[Sysname] interface vlan-interface 1
# Assign an IP address (for example, 192.168.0.1)_to VLAN-interface 1 according to the IP
network segment distribution and usage in the current network.
[Sysname-Vlan-interface1] ip address 192.168.0.1 24
[Sysname-Vlan-interface1] quit
•
Configure static routes
# Configure a static route, with the destination IP address 172.16.1.0 and the next hop IP address
192.168.0.2.
[Sysname] ip route-static 172.16.1.0 255.255.255.0 192.168.0.2
•
Configure VLANs
# Create VLAN 10, and enter its view.
[Sysname] vlan 10
[Sysname-vlan10]
# Assign port GigabitEthernet 2/0/1 to VLAN 10.
[Sysname-vlan10] port gigabitethernet 2/0/1
[Sysname-vlan10] quit
•
Configure MSTP
# Create an MST region named example, map VLAN 10 to instance 1, and set the MSTP revision
level to 0.
[Sysname] stp region-configuration
[Sysname-mst-region] region-name example
[Sysname-mst-region] instance 1 vlan 10
[Sysname-mst-region] revision-level 0
# Activate the MST region configuration.
[Sysname-mst-region] active region-configuration
[Sysname-mst-region] quit
# Configure the switch as the primary root bridge of instance 1.
[Sysname] stp instance 1 root primary
# Enable MSTP globally.
[Sysname] stp enable
For more information about the access function configuration, see H3C S7500E Series Ethernet Switches
Configuration Guide.
Verifying the network configuration
To verify the software version and network configuration, perform display commands in any view.
Task Command
Display the name, model, and running operating system version of the switch display version
Display the current configuration of the switch
display current-configuration
Display the interface status and configuration
display interface brief