Verifying the configuration, Vsan configuration example, Network requirements – H3C Technologies H3C S12500-X Series Switches User Manual

Page 86

# Configure Switch B to operate in FCF mode, and enable the fabric configuration function in

VSAN 2.

system-view

[SwitchB] fcoe-mode fcf

[SwitchB] vsan 2

[SwitchB-vsan2] domain configure enable

# Configure the domain ID as 2.

[SwitchB-vsan2] domain-id 2 static

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

# Enable FSPF globally.

[SwitchB-vsan2] fspf enable

[SwitchB-vsan2] quit

# Create interface VFC 1, and configure it to operate in E mode.

[SwitchB] interface vfc 1

[SwitchB-Vfc1] fc mode e

# Bind interface VFC 1 to interface Ten-GigabitEthernet 1/0/1, and assign it to VSAN 2 as a trunk
port.

[SwitchB-Vfc1] bind interface ten-gigabitethernet 1/0/1

[SwitchB-Vfc1] port trunk vsan 2

[SwitchB-Vfc1] quit

# Assign interface Ten-GigabitEthernet 1/0/1 to VLAN 10 as a trunk port.

[SwitchB] interface ten-gigabitethernet 1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/1] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 2.

[SwitchB] vlan 10

[SwitchB-vlan10] fcoe enable vsan 2

[SwitchB-vlan10] quit

# Enable FSPF on interface VFC 1.

[SwitchB] interface vfc 1

[SwitchB-Vfc1] port trunk vsan 2

[SwitchB-Vfc1] undo fspf silent vsan 2

[SwitchB-Vfc1] quit

Verifying the configuration

# Display FSPF neighbor information on Switch A.

[SwitchA] display fspf neighbor

FSPF neighbor information of VSAN 2(01):

Interface NbrDomain IfIndex NbrIfIndex Dead Time State

Vfc1 2 0x68 0x68 00:01:06 Full

# Display information about the FC routing table on Switch A.

[SwitchA] display fc routing-table vsan 2

Routing Table: VSAN 2

This manual is related to the following products: