H3C Technologies H3C S12500-X Series Switches - Manual (Page 80)

71
Static FC routing configuration example
Network requirements
As shown in Figure 22 , configure static routes to enable any two FCF switches to communicate with each
other.
Figure 22 Network diagram
Configuration procedure
1. Configure Switch A:
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.
(Skip this step if the switch is operating in advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode, and enable the fabric configuration function in
VSAN 1.
system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 1
[SwitchA-vsan1] domain configure enable
# Configure the domain ID as 1.
[SwitchA-vsan1] domain-id 1 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchA-vsan1] quit
# Create interface VFC 1, and configure it to operate in E mode.
[SwitchA] interface vfc 1
[SwitchA-Vfc1] fc mode e
Switch B
Switch A
XGE1/0/1
Switch C
Domain ID: 1 Domain ID: 3
Domain ID: 2
VFC1
XGE1/0/1
VFC1
XGE1/0/2
VFC2
XGE1/0/2
VFC2