H3C Technologies H3C S12500-X Series Switches - Manual (Page 34)

25
Task Command
Display ENode information obtained by a Transit
switch.
display fip-snooping enode [ vlan vlan-id ]
Display FCF switch information obtained by a Transit
switch.
display fip-snooping fcf [ vlan vlan-id ]
Display the FIP snooping rules that have been flushed
(in standalone mode). display fip-snooping rules [ enode | fcf ] [ vlan
vlan-id ] [ slot slot-number ]
Display the FIP snooping rules that have been flushed
(in IRF mode). display fip-snooping rules [ enode | fcf ] [ vlan
vlan-id ] [ chassis chassis-number slot slot-number ]
Display the FIP snooping rules that are being flushed.
display fip-snooping flushing-rules [ enode | fcf ]
[ vlan vlan-id ]
Display information about FIP snooping sessions
(connections between ENodes and FCF switches).
display fip-snooping sessions [ vlan vlan-id ]
FIP snooping configuration example
Network requirements
As shown in Figure 17 , enable FIP snooping on the Transit switch to achieve reliable communication
between the ENode and FCF switch.
Figure 17 Network diagram
Configuration procedure
1. Configure Switch A:
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.
(Skip this step if the switch is operating in advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in Transit mode.
system-view
[SwitchA] fcoe-mode transit
# Create VLAN 10, and enable FIP snooping for VLAN 10.
[SwitchA] vlan 10
[SwitchA-vlan10] fip-snooping enable
Fabric
FCF mode ENode mode
ENode
XGE1/0/2 XGE1/0/1 XGE1/0/2
VFC2
Transit switch
Switch A
FCF switch
Switch B