H3C Technologies H3C S12500-X Series Switches - Manual (Page 44)

35
If you perform the configuration in both system view and VSAN view, the configuration made in VSAN
view applies to the VSAN.
Configuring the fabric timers in system view
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the global
distributed service timeout
period. fc timer distributed-services value
By default, the distributed service
timeout period is 5000
milliseconds.
3. Configure the global error
detection timeout period.
fc timer error-detect value
By default, the error detection
timeout period is 2000
milliseconds.
4. Configure the global
resource allocation timeout
period.
fc timer resource-allocation value
By default, the resource allocation
timeout period is 10000
milliseconds.
Configuring the fabric timers in VSAN view
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Configure the distributed
service timeout period for
the VSAN.
timer distributed-services value
By default, the distributed service
timeout period is 5000 milliseconds.
4. Configure the error
detection timeout period
for the VSAN.
timer error-detect value
By default, the error detection
timeout period is 2000 milliseconds.
5. Configure the resource
allocation timeout period
for the VSAN. timer resource-allocation value
By default, the resource allocation
timeout period is 10000
milliseconds.
Configuring the fabric reconfiguration
IMPORTANT:
The fabric reconfiguration function takes effects only when the fabric configuration function is enabled.
The fabric reconfiguration occurs in the case of a network reconstruction (for example, two fabrics are
merged) or external intervention (for example, the administrator uses a command to initiate
reconfiguration). The fabric reconfiguration triggers principal switch selection, domain ID assignment,
and FC address assignment throughout the fabric.
The fabric reconfiguration includes the following categories: