H3C Technologies H3C S12500-X Series Switches - Manual (Page 98)

87
Displaying and maintaining RSVP
Execute display commands in any view and reset commands in user view.
Task Command
Display RSVP information. display rsvp [ interface [ interface-type interface-number ] ]
Display information about the security
associations established with RSVP neighbors. display rsvp authentication [ from ip-address ] [ to
ip-address ] [ verbose ]
Display information about CRLSPs established
through RSVP.
display rsvp lsp [ destination ip-address ] [ source ip-address ]
[ tunnel-id tunnel-id ] [ lsp-id lsp-id ] [ verbose ]
Display information about RSVP neighbors.
display rsvp peer [ interface interface-type interface-number ]
[ ip ip-address ] [ verbose ]
Display information about RSVP resource
reservation requests sent to upstream devices.
display rsvp request [ destination ip-address ] [ source
ip-address ] [ tunnel-id tunnel-id ] [ prev-hop ip-address ]
[ verbose ]
Display information about RSVP resource
reservation states.
display rsvp reservation [ destination ip-address ] [ source
ip-address ] [ tunnel-id tunnel-id ] [ nexthop ip-address ]
[ verbose ]
Display information about RSVP path states.
display rsvp sender [ destination ip-address ] [ source
ip-address ] [ tunnel-id tunnel-id ] [ lsp-id lsp-id ] [ verbose ]
Display RSVP statistics.
display rsvp statistics [ interface [ interface-type
interface-number ] ]
Clear RSVP security associations. reset rsvp authentication [ from ip-address to ip-address ]
Clear RSVP statistics.
reset rsvp statistics [ interface [ interface-type
interface-number ]
RSVP configuration examples
Establishing an MPLS TE tunnel with RSVP-TE
Network requirements
Switch A, Switch B, Switch C, and Switch D run IS-IS.
Use RSVP-TE to create an MPLS TE tunnel from Switch A to Switch D.