beautypg.com

Configuring a bgp pw – H3C Technologies H3C S12500-X Series Switches User Manual

Page 299

background image

288

To configure an LDP PW:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter VSI view.

vsi vsi-name

N/A

3.

Specify LDP signaling
for PWs, and enter VSI

LDP signaling view.

pwsignaling ldp

By default, no PW signaling protocol is
specified.

4.

Configure an LDP PW,
and enter VSI LDP PW

view.

peer ip-address [ pw-id pw-id ]
[ no-split-horizon | pw-class

class-name | tunnel-policy

tunnel-policy-name ] *

By default, no LDP PW is configured.
If you have configured a default PW ID
for the VSI with the default-pw-id

command, you can use the default PW

ID without providing a PW ID in the peer
command. If no default PW ID is

configured, you must provide a PW ID

in the peer command.

Configuring a BGP PW

To configure a BGP PW, perform the following configurations on PEs:

Configure BGP to advertise VPLS label block information.

Create a BGP PW.

Configuring BGP to advertise VPLS label block information

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enable BGP and enter BGP
view.

bgp as-number

By default, BGP is not enabled.

3.

Configure the remote PE as a
BGP peer.

peer { group-name | ip-address }
as-number as-number

By default, no BGP peer is
configured.

4.

Create and enter BGP L2VPN
address family view.

address-family l2vpn

By default, BGP L2VPN address
family view is not created.

5.

Enable BGP to exchange
L2VPN information with the

specified peer or peer group.

peer { group-name | ip-address }
enable

By default, BGP cannot exchange
L2VPN information with any peer

or peer group.

6.

Enable BGP to exchange
label block information with

the specified peer or peer

group.

peer { group-name | ip-address }
signaling

By default, BGP can exchange
label block information with a BGP

L2VPN peer or peer group.

7.

(Optional.) Permit the local AS
number to appear in routes

from the specified peer or

peer group and specify the
appearance times.

peer { group-name | ip-address }
allow-as-loop [ number ]

By default, the local AS number is
not allowed in routes from a peer

or peer group.