H3C Technologies H3C S12500-X Series Switches - Manual (Page 298)

287
Step Command Remarks
4. (Optional.) Configure the
default PW ID for the VSI.
default-pw-id default-pw-id
By default, no default PW ID is
configured for the VSI.
5. Configure an MTU for the VSI. mtu mtu
By default, the MTU of a VSI is
1500 bytes.
6. (Optional.) Enable the VSI. undo shutdown By default, a VSI is enabled.
Configuring a PW
Configuring a PW class
In a PW class, you can configure PW attributes such as the PW type. To simplify PW configuration, you
can configure PWs with the same attributes by referencing the same PW class.
To configure a PW class:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a PW class and enter
PW class view.
pw-class class-name By default, no PW class is created.
3. (Optional.) Specify the PW
type.
pw-type { ethernet | vlan } By default, the PW type is VLAN.
Configuring a static PW
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSI view. vsi vsi-name N/A
3. Specify static signaling
for PWs, and enter VSI
static view.
pwsignaling static
By default, no PW signaling protocol is
specified.
4. Configure a static PW,
and enter VSI static PW
view.
peer ip-address [ pw-id pw-id ]
in-label label-value out-label
label-value [ no-split-horizon |
pw-class class-name |
tunnel-policy
tunnel-policy-name ] *
By default, no static PW is configured.
If you have configured a default PW ID for
the VSI with the default-pw-id command,
you can use the default PW ID without
providing a PW ID in the peer command. If
no default PW ID is configured, you must
provide a PW ID in the peer command.
Configuring an LDP PW
Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information about
MPLS LDP configuration, see "Configuring LDP."