H3C Technologies H3C S12500-X Series Switches User Manual

Page 89

Resv Style : -

Tunnel mode : -

Reverse-LSP name : -

Reverse-LSP LSR ID : - Reverse-LSP Tunnel ID: -

Class Type : - Tunnel Bandwidth : -

Reserved Bandwidth : -

Setup Priority : 0 Holding Priority : 0

Affinity Attr/Mask : -/-

Explicit Path : -

Backup Explicit Path : -

Metric Type : TE

Record Route : - Record Label : -

FRR Flag : - Backup Bandwidth Flag: -

Backup Bandwidth Type: - Backup Bandwidth : -

Route Pinning : -

Retry Limit : 10 Retry Interval : 2 sec

Reoptimization : - Reoptimization Freq : -

Backup Type : - Backup LSP ID : -

Auto Bandwidth : - Auto Bandwidth Freq : -

Min Bandwidth : - Max Bandwidth : -

Collected Bandwidth : -

# Execute the display mpls lsp command or the display mpls static-cr-lsp command on each switch to
display the static CRLSP information.

[SwitchA] display mpls lsp

FEC Proto In/Out Label Interface/Out NHLFE

1.1.1.1/0/1 StaticCR -/20 Vlan1

2.1.1.2 Local -/- Vlan1

[SwitchB] display mpls lsp

FEC Proto In/Out Label Interface/Out NHLFE

- StaticCR 20/30 Vlan2

3.2.1.2 Local -/- Vlan2

[SwitchC] display mpls lsp

FEC Proto In/Out Label Interface/Out NHLFE

- StaticCR 30/- -

[SwitchA] display mpls static-cr-lsp

Name LSR Type In/Out Label Out Interface State

static-cr-lsp-1 Ingress Null/20 Vlan1 Up

[SwitchB] display mpls static-cr-lsp

Name LSR Type In/Out Label Out Interface State

static-cr-lsp-1 Transit 20/30 Vlan2 Up

[SwitchC] display mpls static-cr-lsp

Name LSR Type In/Out Label Out Interface State

static-cr-lsp1 Egress 30/Null - Up

# Execute the display ip routing-table command on Switch A. The output shows a static route entry with
interface Tunnel 0 as the egress interface.

This manual is related to the following products: