Eneo PNR-5108 - Manual (Page 96)

Operating Instructions
88
− Domain Name: Allows you to enter the device's domain name registered on a DNS server if the
device uses the domain name service.

: Select the devices to register by checking the box beside each device name in the list. Selecting
the Select All box selects all devices in the list.
NOTES:
 Depending on the model, the device may not be supported even though the iNEX program supports the
device's protocol. Ask your dealer or distributor about supported models.
 If the device uses the ONVIF TM
Conformance protocol, you can select either the manufacturer (or iNEX
protocol) or the ONVIF
TM
Conformance protocol. However, it is possible that one or both of them are not
supported depending on the device model. Ask your dealer or distributor for details. Refer to the device
User’s Manual about enabling the ONVIF
TM
Conformance protocol in the device, as procedures may differ
for each model.
2. Click the Add Devices button at the bottom.
 Name, Address, Device Type: Displays the name, IP address and type of the selected device. The
name will be updated automatically depending on the settings of the device.
 ID, Password: Enter the user ID and password which you set in the device in order to connect to that
device remotely. The connection to the device is allowed only to the users under the Administrator
group of the device, and recording is allowed only to the admin user under the Administrator group
of the device.
 Recording Service: Select a recording service (supported only for the network video devices). The
device is registered on the recording service and the NVR system performs recording according to a
recording schedule. The channel number of the recording service indicates the maximum number of
cameras that can be registered, and the name indicates the name of a recording service, which was set
during the Service menu setup. When selecting the Do not record option, the iNEX program treats
the device during the Schedule setup as though it was not registered and does not perform any of the
scheduled activities associated with the device. If you delete the device from the recording service
after some recording has been done, you cannot search or play back the previously recorded video
though you register the device again. You can check the list of devices registered on the recording
service on a Device Setup tab while setting up the recording service in the Service menu. Refer to
Chapter 14
— Storage Management (p. 107) for details.
 Streaming Service: Select whether or not to use the streaming service for monitoring video from the
device. Streaming service allows remote monitoring of live images in a WAN environment (up to two
users). The number of channels that can be streamed equals the number of channels that can be recorded.
Refer to Chapter 11 — Streaming (p. 87) for details.
 Apply to All Devices: Select to apply the same user ID and password to all selected devices if you
selected more than one device and the selected devises have the same user ID and password.