Upgrading device’s software checking device status, Upgrading device’s software, Upgrading device ’s software – Eneo PNR-5108 User Manual
Page 102: Checking device status
Operating Instructions
94
Upgrading Device
’s Software
If you have an upgrade file, selecting Firmware Upgrade from the device menu allows you to upgrade
the device’s software remotely (supported only for devices which use the iNEX protocol).
You can upgrade software of several devices at the same time.
Clicking the (Multiple Firmware
Upgrade) button above the Site panel displays the following screen (supported only for devices which use
the iNEX protocol).
Click the
button at the top right corner and select
an upgrade file. If the device is a PC-based DVR,
check the PC Based DVR box and click the
button. The list of available devices is displayed.
Selecting Show all devices displays all registered
devices. Select devices and click the Upgrade
button at the bottom to start upgrading.
Checking Device Status
Click All Devices in the Site panel and then a device in the Site List panel. The device status is displayed in
the Recording Status field (Connected: Recording is available, Disconnected: Recording is not available).
Clicking the arrow button (
) beside each device name displays the list of inputs and outputs supported by
the device. You can check the input and output device’s status (Record: During recording in the Time-Lapse
Recording or Event-Based Recording mode, Panic: During recording in the Instant Recording mode,
Idle: Ready to record).