Eneo PNR-5108 - Manual (Page 24)

Operating Instructions
16
NOTES:
 If the device is a DVR, it might be necessary to enter the DVR port numbers depending on the specifications
and version of the DVR.
 When registering a four-channel network video transmitter which uses the iNEX protocol, all four cameras
are automatically registered even if some of the four cameras are disabled.
4. Click Device Group in the Site panel, and then the
button at the bottom of the Site panel. The Add
Device Group window appears.
 Name: Enter the device group name.
 Location: Select an upper group to which the device group will belong.
 Select Devices Below, Selected Device List: Check the box beside cameras in the left panel, and
the selected cameras are added to the right panel.
Clicking the OK button completes the device group registration.
5. Check that the device was added to the device group correctly. Click Device Group in the Site panel
and then the arrow button ( ) beside Device Group. Clicking the registered group displays the list
of devices added to the device group and connection status in the Site List panel. If the connection was not
made properly, the network disconnection log is displayed (only for devices registered on the recording
service). Refer to Appendix – Network Disconnection Log (p. 143) for details about the network
disconnection log.