Eneo PNR-5108 - Manual (Page 45)

Network Video Recorder
37
Screen Display
 Display OSD: Sets up the OSD display setting
and information to be displayed on a camera
screen. The Opacity slide bar allows you to
adjust the opacity of OSD (On Screen Display),
OSD Magnification changes the OSD size
depending on the screen size. See below about
OSD information.
− Camera Title: Displays the camera name
set in the iNEX program.
− Title Bar: Separates the title display area
from an image display area at the top.
− Status Icon: Displays status OSD. ( (Red):
During Time-Lapse or Event-Based recording,
(Orange): During Instant recording, : In the
PTZ mode, : In the camera sequence mode,
: In the zoom mode, : In the two-way audio
communication mode)
− PTZ: Displays direction control buttons which is displayed on the camera screen when controlling
a PTZ camera.
− Date, Time: Displays the date and time of the NVR system.
− Event Alert: Highlights the camera title bar in red when an event occurs in the device. The alert will
release after the event dwell time (sec.) from the time an event is detected or when you select the camera
screen if you set up the Event Alert Dwell Time setting to Manual Off.
− Motion Block: Displays the area where motion is detected with red blocks when a motion detection
event occurs in the device (supported only for network video transmitters which use the iNEX protocol).
− Text-In: Displays the text-in information on the screen when a text-in event occurs in the device
(1x1 screen format only). This feature is supported only for devices which use the iNEX protocol.
 Control Toolbar: Adjusts the opacity of the control toolbar on the camera screen.
Camera Title,
Status Icon, Date/Time
Event Alert Motion Block Control Toolbar