ARM Electronics XR&HD480 OSD - Manual (Page 72)

User’s Manual
71
„ Alarm In
This item allows users to enable / disable alarm input detection. According to
the application, select (Normal Open) or (Normal Close) to
enable the alarm input detection or select to disable the detection.
If users set this item to but no device is installed, the alarm will be
triggered and the Event Icon will always be displayed on the screen until this
item is changed to , or a device is installed to the unit.
„ Alarm Out
This item allows users to assign an alarm output on certain channel to
activate the relays. These signals can be used to drive a light or siren to
caution an alarm event. The available options and the corresponding
activated alarm outs are listed as below table:
Option Activating Relay Option Activating Relay
Alarm Out A Alarm Out B & Alarm Out C
Alarm Out B Alarm Out A & Alarm Out C
Alarm Out C All Alarm Out
Alarm Out A & Alarm Out B No Alarm Out
„ Event Trigger Preset
For dome cameras, this item allows users to enable automatic pan/tilt of the
dome camera lens to a selected preset point (1~255) once an event was
triggered. Alternatively, select to disable this function.
„ Copy Event Settings
This item allows users to copy the event settings of the current selected
analog camera to any other connected analog cameras. Enter this menu and
select one or more target analog cameras. Then select to apply
the settings.
Copy Event Settings
COPY TO:
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16
Select All Deselect All Confirm Cancel