ARM Electronics XR&HD480 OSD User Manual
Page 60
User’s Manual
59
Camera Select
The item is used to select a desired channel for setting the parameters. Move
the cursor to
using UP / DOWN keys. Press ENTER again to confirm the setting.
Normal PPS
Normal PPS (Picture per Second) is used to set the recording rate for normal
status. Please note that the normal PPS for all channels can be added up to
the maximum PPS for each Record mode. To increase one channel’s PPS,
users may have to reduce others’ first. Event PPS is not restricted to this rule,
since a smart event calculating program of the unit will handle the total PPS to
meet the maximum PPS with a correct weighting. For example, if channel 1
is set to event mode with 30PPS, the remaining 30 PPS will be equally
distributed to other 15 channels, which means each channel will be set to 2
PPS.
Normal Qlty
The item is used to set the picture size for normal status recording. The
available options are listed as follow:
ABR (KByte)
Event Max PPS
Event Max PPS is used to set the event recording rate for Event status.
Normally, the Event PPS is set to equal or greater than Normal PPS; the
setting is depending on the application. If the Event PPS is set to <0>, the
Premium H.264 DVR
stops recording event video during alarms.
Event Qlty
The item is used to set the picture size for event status recording. The
available options are
Event Active
Users are allowed to choose which alarm type will be recorded. The available
options are