ARM Electronics XR&HD480 OSD - Manual (Page 61)

User’s Manual
60
< ezRecord Setup >
This item aims to ease the complicated record settings, and to make the setup much easier.
Note that the item can be reached only when users select as the option for
.
Select from and press ENTER, the sub-menu appears
as below figure:
ezRecord Setup
How Many Days To Record
Daytime Record
Night Record
Weekend Record
Average Normal PPS
Average Normal Quality
Day ABR (KByte)
Night ABR (KByte)
Weekend ABR (KByte) 11 Days
Yes
Yes
Yes
30
Best
0
0
0
Follow these steps to Setup ezRecord:
• Select and press ENTER, then press UP/DOWN to
choose an option. The average normal PPS & Quality will be adjusted automatically.
The maximum of days depends of the size of the HDD. In other words, the larger the
size of the installed HDD, the more days the unit can record.
• Move to and press ENTER. This item is for users to select whether
users want the DVR to record during daytime. If so, use UP/DOWN to select to
enable daytime recording; or select to disable.
• Repeat the same procedures through the 3rd and 4th item, respectively. Note that
will be inaccessible if users select for the item Schedule> in .
• Select and press ENTER, then press UP/DOWN to make a
choice. The will be computed automatically.
• Select and press ENTER, then press UP/DOWN to make a
choice. The will be computed automatically.
• Day/ Night/ Weekend ABR (KByte) are “read-only” information showing the Average Bit
Rate of day/night/weekend recording.
NOTE:
The current number of connected cameras will affect the recording quality
automatically calculated through the . Therefore, once users
disconnect cameras or connect more cameras to the unit, users should reset the
.