ARM Electronics XR&HD480 OSD - Manual (Page 65)

User’s Manual
64
Sequence Setup
The Sequence Setup menu allows users to set the camera sequence schedule and dwell
time for main and call monitor. Select in Main menu and press ENTER;
the menu displays as follows. Items in the Sequence Setup menu are described in the
subsections.
Sequence Setup
Main Monitor Dwell
Main Monitor Schedule
Call Monitor Dwell
Call Monitor Schedule 5 Sec
5 Sec
NOTE: When the second main monitor is connected, there will be extra menu items
for configuring dwell and schedule settings of the second main monitor.
< Main / Call Monitor Dwell >
These items are used to set the dwell time, which is the duration of time elapsed before
switching to the next channel, of the Main / Call Monitor. The dwell time is in the range of 1
to 120 seconds.
< Main / Call Monitor Schedule >
These items are used to set sequence schedules of the Main / Call Monitor. Move the
cursor to
Main Monitor Schedule
CH1 ► CH2 ► CH3 ► CH4 ►
CH5 ► CH6 ► CH7 ► CH8 ►
CH9 ► CH10 ► CH11 ► CH12 ►
CH13 ► CH14 ► CH15 ► CH16 ►
Confirm Cancel
Follow these steps to set a sequence:
• Press LEFT / RIGHT direction keys to move to previous / next sequence order.
• Press UP / DOWN keys to assign a channel to that order in the sequence.
• Continue the steps until the sequence is completed.
• To setup a sequence with less than 16 entries, select to end the sequence.
A sequence can have up to 16 entries, while the Call Monitor may have less due to the limit
of IP camera display. The sequence can include one or more cameras multiple times.