Westermo IDW-90 AT User Manual
Page 91
91
6620-3200
Command Syntax
In response to this command, the modem will report one or more lines of informa-
tion text as defined below. Information text format conforms to V.250; each line is pre-
ceded by a
changed by writing new values to the contents of registers S3 and S4, respectively.)
The modem may generate a single line or multiple lines, followed by a standard OK final
result code. For example, if call setup failed, only that result is useful. Each information
text line is formatted as follows, including one or more key=value pairs:
Command
AT!#UD
Response
DIAG
Defined Values
DIAG 5 hexadecimal characters (44h, 49h, 41h, 47h, 20h)
<
Left angle bracket (less than sign) (3Ch)
token Unique 32-bit hexadecimal string
2A4D3263(32h, 4h1, 34h, 44h, 33h, 32h, 36h, 33h)
space space character (20h)
Key
One- or two-digit hexadecimal number (see Key in Table 8)
=
Equal sign (3Dh)
Value Any string as defined below (Table 8 as appropriate)
>
Right angle bracket (greater than sign) (3Eh)
Unless otherwise noted, all values are hexadecimal numbers. Any numeric values from
tables in ITU V.58 are converted to hexadecimal. Multi-digit values are reported MSD
first. Leading 0’s may be deleted. See examples in Table 17.
callCleared codes from 3.6.4/V.58-1994
callCleared: indicates that the DCE has gone on hook and that the previously existing
network connection has been cleared. These values are hex, converted from decimal in
V.58. callCleared codes are described in Table 16.