Westermo IDW-90 AT - Manual (Page 42)

42 6620-3200
5.6 Remote access control
By using the following commands a table can be set up which allows only dedicated call-
ers to get a connection to the remote management facilities inside the TA.
If this list is empty (default) or one entry with a star (*) is set, any incoming call is
allowed.
Every incoming call that does not match one of the entries of racctab will be rejected
with the ISDN cause “call rejected”.
racctabx nn/ss set entry number x to ISDN number nn
and sub address ss
racctabx - clear entry number x
racctabx * Allow all incoming calls to be accepted
racctabx Show entry number x
racctab Show all entries
Maximum number of entries = 5
Maximum length of ISDN number = 20 digits
Maximum length of sub address = 20 digits
The ISDN number can contain wildcards:
*: represents one or more digits
?: represents exactly one digit
Example:
racctab1 1234567890 ; accept the only specified number
racctab2 *456* ; accept all numbers with 456 somewhere in the middle
racctab3 ?2345678?? ; accept all numbers with 2345678 in the middle preceded
by one digit and followed by two digits.
racctab3 * ; accept all incoming calls
racctab3 - ; clear entry no. 3