Westermo IDW-90 AT - Manual (Page 85)

85 6620-3200
trcdln – length of trace entry
trcdln xx set trace buffer entries to a maximum length of xx. (default: 256).
trcon – start trace write
trcon set trace to active regarding tracemask.
trcoff – stop trace write
trcoff set trace to OFF independent of tracemask.
trcclr – clear trace buffer
trcclr clear actual tracebuffer contents.
trcread – read trace buffer
trcread Output of the complete trace buffer in hexadecimal chars
(ASCII, max. line length 72 chars).
Every entry of the trace buffer is output using the following format:
Entry number
Sequence number of entry
Timestamp in units of 10 ms
TypeAndSource Source of traceentry:
bit0–7 : type from tracemask
bit8–14 : source of traceentry:
0500 : D channel layer 1 (dl1)
0600 : D channel layer 2 (dl2)
0700 : D channel layer 3 (dl3)
0900 : Serial line (sl1)
bit15 : 0xxx : incoming event (from ISDN line)
8xxx : outgoing event (to ISDN line)
“FFFF” : Reset for firmware
Length Length of following data bytes
Databytes Data bytes; continued lines are indicated
by an “>”.
Coding of trace data bytes dependent of TypeAndSource: