Westermo IDW-90 AT User Manual
Page 22
22
6620-3200
!&W – Store active configuration
The active configuration for the analogue modem will be stored in non volatile memory.
AT!&W
X – Reduce result messages
Reduces the number of result messages after trying to set up a connection
ATX0
“CONNECT” only
ATX1
“CONNECT” with line speed, “BUSY”, “NO DIALTONE” not used
ATX2
“CONNECT” with line speed, “BUSY” not used
ATX3
“CONNECT” with line speed, “NO DIALTONE” not used
ATX4
“CONNECT” with line speed, all messages used (default).
Z – Load stored settings
The active configuration will be replaced by the stored configuration.
Must be the last command in an AT command line.
ATZ
This command will also cause a soft reset of the analogue modem with a recall of stored
configuration profile.
&Z – Store call-number
Stores dialling number nn as entry number x into the telephone list (x = 1..3).
AT&Zx=nn
set entry number x to dialling number nn
AT&Zx
shows entries number x.
AT&Z
show all entries.
#Z – Define own msn
Defines the msn nn for the data port.
If the number is set to “*“ (default), all incoming calls are acceptable.
The msn can be displayed by command AT#H or AT&V1.
AT#Z=nn
The msn is automatically stored to non volatile RAM.
**
Executes one configuration command, for definition of commands
see IDW-90+Configurator commands section.
AT**