Westermo IDW-90 AT - Manual (Page 62)

62 6620-3200
*wiol – General IO list
This command is used to program the list of IO entries with parameters and data.
The list can contain up to 10 entries
Syntax:
Set up a service entry:
*WIOL=, , , , , ,
, , , ,
Request the format string:
*WIOL=?
*WIOL : (1-10), (0-7),(0-3), (0-255), (0-1), (0-20 char),
(0-160 char), (0-20 char), (0-2), (0-8 char), (0-20 char)
List all table entries. Listing will pause every 3rd entry and wait
for any key hit to continue. ESC will terminate.
*WIOL?
List entry 3.
*WIOL=3?
IO entry number, up to 10 entries can be defined.
IO entry service
0=NONE No service defined for this entry
1=DIAL Makes a connection to the number defined in .
2=SMS Destination number of the SMS
SMS-message
SMS service provider number
SMS protocol type (0=NONE, 1=UCP, 2=TAP)
Password if required by provider.
3=TEXT Make a connection to number defined in and transfer text defined in
.
4=EMAIL Reserved for future use, service not implemented.
5=OUT Make a connection to the number defined in and set/pulse the remote
output according to pattern defined in string defined in .
The connection is terminated after the pattern is transferred.
6=CMD AT command specified by is executed when the entry is triggered.
7=TRANS Makes a connection to number defined by , IO is transferred transparently
between the two units. The transparent mode must be ended by a timeout.