Westermo IDW-90 AT - Manual (Page 15)

15 6620-3200
&F – Load factory defaults
Factory default will be loaded, ISDN protocol setting and msn’s will not be overwritten.
(for storing in non volatile memory please use the command AT&W).
AT&F0 Setup all parameters concerning data port
AT&F1 Setup all parameters including ISDN protocol and msn settings.
!&F – Load factory defaults
Factory default will be loaded for the analogue option
(for storing in non volatile memory please use the command AT!&W).
AT!&F The analogue modem loads the factory default configuration (profile)
H – Disconnect
Disconnects existing ISDN data connection, after issuing the Escape sequence (+++).
To enter the ATH command during an active data connection you must use the follow-
ing sequence "<1 sec pause> <+><+><+> <1 sec pause>" to reach the online command
mode.
The time gap between all three plus signs may not exceed 1 sec.
The escape sequence is transmitted transparently to the remote device.
The timeout after sending the "escape sequence" <+><+><+> will increase if the
configuration parameter "txfwd" will rise. The default value of "txfwd" is set to "0".
I – Display version information
Displays different information about version number and settings:
ATI0 Returns the “Modem”-type; name of the terminal adapter (“IDW-
90“)
ATI1 Returns internal checksum (“??”)
ATI2 Returns “OK”
ATI3 Returns version string: “410045vv” vv = version number.
ATI4 Returns manufacturers name: “Westermo Teleindustri AB”
ATI5 Returns ISDN selected D-Channel protocol: “0 – DSS1”
ATI6 Returns copyright string: “(c) Copyright Westermo Teleindustri AB”
ATI7 Returns the status of the IDW-90 configuration switches.
1 1 1 1
“00000000.00000000.00000000.00000000”
SW1 SW2 SW3 SW4
‘0’ = switch OFF and ‘1’ = switch ON.
ATI9 Returns plug and play ID string
ATI99 Returns software version creation date