Westermo IDW-90 AT - Manual (Page 16)

16 6620-3200
!I – Display version information for analogue modem
Displays various information about version number and settings for the analogue modem:
AT!I0 Reports product code,
AT!I1 Reports the least significant byte of the stored checksum in decimal
(see firmware release notes). Reports 255 if the prestored checksum
value is FFh.
AT!I2 Reports “OK”.
AT!I3 Reports identification codes in the form RevisionName-Modulation
where:
RevisionName =Product family, CX06833.
Modulation = V34 or V32
Example: CX068330-V34
AT!I4 Reports OEM Manufacturer string e.g.: Westermo IDW-90
AT!I5 Reports Country Code parameter, e.g., 42.
AT!I6 Reports modem data pump model and internal code revision
AT!I7 Reports OK.
&K – Flow control
Selects the flow control behaviour of the IDW-90 while in data communication phase.
AT&K0 No local flow control between the DTE and IDW-90 is used
AT&K3 Local flow control is set to hardware handshake RTS/CTS (default)
AT&K4 Local flow control is set to software handshake XON/XOFF
!-K – MNP Extended Services
Enables or disables conversion of a V.42 LAPM connection to an MNP 10 connection.
The parameter value, if valid, is written to S40 bits 0 and 1.
AT!-K0 Disables V.42 LAPM to MNP 10 conversion. (default)
AT!-K1 Enables V.42 LAPM to MNP 10 conversion.
AT!-K2 Enables V.42 LAPM to MNP 10 conversion; inhibits MNP Extended
Services initiation during V.42 LAPM answer mode detection phase.
!%L – Report Line Signal Level
Returns a value which indicates the received signal level. The value returned is a direct
indication of the receive level at the MDP, For example, 009 = –9 dBm, 043 = –43 dBm,
and so on. This command is only valid in online command mode.
#M – Received CLID
Shows the called line identification (CLID) that is received with an incoming call – this is
the number of the called party addressed on the local S-bus (selected msn).
AT#M