Welltech LP-803 v.3.07 - Manual (Page 79)

LAN Phone 803
User Manual
Welltech Technology Co., Ltd.
79 / 90 2014/07/22
(Figure 1)
Item Explanation
ICMP Not Echo Default: Disable; When this function was set up “Enable”, LP803 will
not responseto the message of ping.
Provide options: Disable, Enable.
Anonymous Call Default: Disable; When this function was set up Type 1/Type 2, LP803
will use the anonymous Caller ID.
Provide options: Disable, Type 1 ( [email protected] ),
Type 2 ( [email protected]) 。
*This function must be supported from SIP Server.
Management from
WAN
Default: Enable; Allow users login system from WAN Port.
When this function was set up Disable, users can only login LP803 from
LAN Port.
Provide options: Disable, Enable.
WEB Login Port Default: 9999; set up web login port location. This column can only
enter numbers; maximum length is 5 bytes with a range of 1~65535.
Telnet Login Default: Enable; Allows using Telnet to login system. If the setting is
disable, User can’t use Telnet to login LP803. Provide drop-down
options: Disable, Enable.
IP Dialing Format Default: Type 1 ( [email protected] ); When this function was set up Disable,
LP803 can not dial IP.
Provide options: Disabled, Type 1 (
[email protected] .), Type 2 (x.x.x.x).
Send Flash event Default: Disable; Send the type of call waiting.
When a user presses [Hook/Flash (Transfer)] on LP803, it will send out
event messages depending on the type of user selected to the other
side.
Provide options: Disable, DTMF Event, SIP Info.
Disable: Send out [SIP/DSP, Content-Type=applicatio-sdp].
DTMF Event: Send out [RTP event, Payload type=RTP event Flash].
SIP Info: Send out [SIP, Request: INFO
sip:xxx@xxxx ], [Message
Body Signal=16, Duration=250].
Transfer Key Mode Default: Attend Transfer; The settings have two method that can