Welltech LP-803 v.3.07 - Manual (Page 7)

LAN Phone 803
User Manual
Welltech Technology Co., Ltd.
7 / 90 2014/07/22
*Special Applications: Door control board connection.
1. This feature requires to produce a different phone line cable.
2. Line 1、Line 2 are relay’s second set of contacts (Connected to relay the same pin), Line 3、
Line 4 are relay’s first set of contacts (Connected to relay the same pin). In use time, these
contacts will reference web page setting, They have Normal Open(
Always open ) or Normal
Close( Always short ) status.
3. Please use the two contacts to connect door control board PCBA. Than user can use this
LP803 to control door access devices.
Note. Reference Page 85, Management > Advanced table item 『Relay Control』 and 『Relay
Mode』Explanation.
1.5.1. Network Environment Setting
Netwrok Mode: Default NAT Mode
WAN Port: DHCP Client Mode
LAN Port: DHCP Server Enable, IP Address: 192.168.123.1, Mask: 255.255.255.0
1.5.2. Connection
Please connect the personal computer to LP803 LAN port, then set up computer Ethernet to
configure DHCP mode. The computer will get DHCP IP address. (ex. 192.168.123.150). Use Web
browser at your computer at
http://192.168.123.1:9999 to enter webpage setup mode of LP803.
1.6. Basic Operations
1.6.1. Phone function
1.6.1.1. Key function
Key Explanation Remark
1 “1”，“-“，“٫”，“!”，“?”，“"”，“@”
2 “2”，“a”，“b”，“c”，“A”，“B”，“C”
3 “3”，“d”，“e”，”f”，“D”，“E”，“F”
4 “4”，“g”，“h”，“I”，“G”，“H”，“I”
5 “5”，“j”，“k”，“l”，“J”，“K”，“L”
6 “6”，“m”，“n”，“o”，“M”，“N”，“O”