Wavecom W61PC V7.5.0 - Manual (Page 30)

20  First start WAVECOM Decoder W61PC/LAN Manual V7.5
 Tune the demodulator to the correct center frequency and set the correct level.
GUI
The user interface of the application conforms to standard WINDOWS interface guidelines. The main pro-
gram window is shown in this section. This is the window you will see after setup has been completed as
described in the preceding paragraphs.
The WINDOWS elements TOOLBAR, WAVECOM TOOLBAR, LEVEL INDICATOR and SPECTRUM INDI-
CATOR may be moved anywhere in the screen as required. In the View menu the user may show or hide
all window elements. By default, all elements are visible.
Please be aware that the appearance of the GUI will vary depending on the product, software version and
operating system.
Command Line Parameters
You can pass information to the application by adding command line parameters.
The following commands are valid:
/i
The name of the INI file that is located in the same directory as the decoder application. Alternatively a
path may be entered.
/n
The number of the card to be connected (a value between 1 and 8).
/c
The name of the computer to be used for the connection
 localhost (not case sensitive) or 127.0.0.1 means that you work with cards on the local comput-
er.
 Computer name or the IP address plus the port number to connect to another computer. The port
number must be entered on the WAVECOM Server Control screen. If a port number is not provid-
ed, then default port 33233 is used.
/l
 Speed limit of the connection to the server. This attribute is a choice of “9600”, “14400”, “19200”,
“56k”, “64k”, “128k”, “512k”, “1M”, “2M”, “5M”or “10M”. If no /l option is used, the speed is un-
limited.
Examples (for W61PC):
 W61PC.EXE /i config1.ini
 W61PC.EXE /i "\configuration\setupAB.ini"
 W61PC.EXE /n 2 /c W61Server:5800