beautypg.com

Classifier code check sequences, Classifier modulation settings – Wavecom W61PC V7.5.0 User Manual

Page 262

background image

252

Classifier (Optional)

WAVECOM Decoder W61PC/LAN Manual V7.5

Classifier Code Check Sequences

From this list, the desired mode of operation of the CCC is selected. Each process performs one or more
steps to narrow down the possible candidates for eventual successful signal determination or decoding.
The availability of more or less complex processes allows the user to select the process which is best suit-
ed to his purposes.

The process selected is shown in the status line.

Process

Steps

P1

Only classification is performed, but no decoding.

P2

Classification and table check are performed, but no decoding.

P3

Classification, table check and code check are performed, but no decoding.

P4

Classification and table check are performed and finally the signal is decoded if a mode with an associat-

ed, valid detector was found

P5

Classification, table check and code check are performed and finally the signal is decoded if a mode with

an associated, valid detector was found.

Classifier Modulation Settings

These settings control the behavior of the classifier. See the section on

Classifier Code Check HF (CCC)

on page 249 for details. Note that the Refresh List option is not available when the classifier is used with
the CCC.

This manual is related to the following products: