Wavecom W61PC V7.5.0 - Manual (Page 24)

14  Setup WAVECOM Decoder W61PC/LAN Manual V7.5
W61LAN Remote Mode with WAVECOM GUI
 Install the W61PC software on the computer that you will use to control the W61LAN
 Connect the W61LAN to the LAN
 Check if the W61LAN computer is visible on your LAN (remember the firewall may block ping and
ICMP)
 Start the W61PC application
 Select a W61PC card for remote control by using the Configuration | W61PC Card… menu
 Disconnect, select Remote Computer and enter the name of the W61LAN remote computer
(“W61LANnnn”) or its IP address. Enter the port number (default is port 33233) and select the
speed (10M for LAN)
 Click Connect
 Select the card and close the “W61PC Card” window by pressing Done
 Start a mode
The selected entry is stored in the card’s initialization file (*.ini file) and is available when the W61PC ap-
plication is restarted at a later time. The settings may be changed at any time.
Note: The version of the W61PC software on the controlling client computer must be the same as that on
the W61LAN.
W61LAN Remote Desktop Operation
Remote Desktop (RD) is a client-server application and part of the Windows XP Professional operating sys-
tem, using port 3389. Remote Desktop can be used to remotely control a W61LAN, which acts as the RD
server, while the client resides on the controlling host.
To use Remote Desktop follow these steps:
 Connect the W61LAN to the LAN
 Check if the W61LAN computer is visible on your LAN (remember the firewall may block ping and
ICMP)
 Start the RD client on the controlling computer by clicking Remote Desktop Connection in Start
| All Programs | Accessories | Communications
 If the RD connection cannot be established check your firewall settings (port 3389 must be open)